Maintenance at a Glance
| Component | Clean | Replace |
| Dust Bin | After each clean / as needed | As needed |
| Filter | Every time you empty the bin | Every 6–12 months |
| Brushroll | Regularly / as needed | Every 6–12 months or when worn |
| Side Brushes | Regularly / as needed | When visibly worn |
| Mop Pad | Auto-washed after each wet clean · Machine wash every 3 months | Every 2 years or as needed |
Emptying the Robot Dust Bin
After each cleaning session or as needed
|
1
Press the release button on the back of the robot and slide out the dust bin. 2
Hold over a trash can. Press the release button while lifting the lid using the finger slots. 3
Empty the debris. Optionally wipe the bin with a damp cloth. 4
If washed, air-dry for 48 hours before reinserting. |
Cleaning the Filter
Every time you empty the dust bin · Replace every 6–12 months
|
1
Remove the dust bin and take out the orange filter using the tabs. 2
Lightly tap the filter over a trash can to remove dust and dirt. 3
Use a dry cloth or soft brush for any remaining debris. Reinsert the filter, then slide the dust bin back until it clicks.
🚫
Never use water or soap on the filter — this will permanently damage it. |
Cleaning the Brushroll
Regularly / as needed · Replace every 6–12 months or when visibly worn
|
1
Push up on the tabs of the brushroll door and lift it off. 2
Remove the brushroll and take off the end cap. Clean off all hair and debris. 3
Replace the cap and reinstall the brushroll, inserting the flat end first. 4
Close the brushroll door and press down until both sides click into place. |
Cleaning the Side Brushes
Regularly / as needed · Replace when visibly worn
|
1
Turn the robot over. Pull the side brush off the post on the bottom of the robot. 2
Carefully unwind and remove any hair or string from the brush and post. 3
Gently wipe the brush with a dry cloth. Clean the side brush post on the bottom of the robot. 4
Align the square hole of the brush with the square post and press until it clicks. Spin the brush to confirm it moves freely. |
Cleaning or Replacing the Mop Pad
Auto-washed after each wet clean · Machine wash every 3 months · Replace every 2 years
After every wet clean, your NeverTouch™ Pro Base automatically washes and dries the mop pad. Additional machine washing or replacement is only needed periodically.
|
1
Carefully pull the mop pad away from the pad plate. 2
Slide the pad off to one side. 3
Slide a clean or new pad into the edge of the plate. Press lightly to secure. Machine wash every 3 months on a gentle cycle. Mop pad colour may vary by model. |
